Usa-spec CD Changer Owner's Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 7
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
DiscountCarStereo.com
PLAYING CHANGE (DISC CHANGE)
Press SIDE button (preset #5, on radio that has a built-in 6 disc changer, this button is labeled
with a disc symbol) and advance the Playlist.
CHANGING SOURCE TO AM/FM/CD/CASSETTE
When a source other than the iPod (i.e. Radio, Cassette etc) is selected on the radio, the
iPod will pause.
5. INSTALLATION INSTRUCTIONS
1. Decide to use CD changer or XM control first, then set DIP switch #3 and #4 accordingly.
(See ABOUT THE PA11-GM Section of this manual). The interface is preset to CD
Changer mode at the factory.
2. Set DIP switch #2 to “OFF” only if “Direct Mode” is preferred (this option allows limited
ipod control from the GM radio and full control of the ipod using the ipod buttons.)
3. Remove radio from dash
4. Unplug the 24 pin and 12 pin connectors from the radio and connect them to the CAS-
G7i cable
5. Connect the CAS-G7i cable 24 and 12-pin connectors to the radio
6. Connect the CAS-F12 cable to the CAS-G7i cable. Connect the round DIN connector on
the CAS-F12 cable to the interface “Radio” connector. Go to step 12 if there is no factory
XM receiver in your vehicle.
7. Locate the XM Receiver “DATA” wire. It is connected to either pin 7 or pin 15 of the
connector harness on the receiver box. (The XM tuner locations may vary see Appendix
A on manual for XM tuner locations.)
8. Cut this “DATA” wire approximately 4 inches away from the receiver box
9. Immediately and securely tape the open end of the wire that goes into the car to prevent
electric short circuits with car body, or with other wires.
10. Splice the other end of the “DATA” wire (receiver side) with the blue wire that comes with
the PA11-GM interface.
11. Plug the “DATA” wire (blue) into the PA11-GM interface labeled “XM Receiver”.
12. Connect the audio output of your auxiliary source to “AUX” input jacks on the PA11-GM
interface box if the additional AUXILIARY option is selected by setting DIP switch #1 to
“OFF” position.
13. Reinstall radio to dash
Page view 5
1 2 3 4 5 6 7

Comments to this Manuals

No comments