Usa-spec PA15-HON3 Owner's Manual download pdf (Page 11)

SECTION 4 CABLE CONNECTIONS

Step 1- Decide which MODE to use and set PIP switches according to information in Section 3.

Step 2- Must remove or eject all CDs from radio.

Step 3- Remove radio out from dash. .

Step 4- Plug the 14-pin male connector on USA SPEC CAS-H2y cable to radio. If a factory cable has the same

identical 14-pin male connector already connected to radio, unplug the factory cable from radio first.

Step 5- If DIP switch #2 is at OFF Position and the vehicle has factory XM receiver, go to Step 12

Step 6- Plug the factory 14-pin male connector to USA SPEC 14-pin female connector on CAS-H2y cable.

Refer to Fig. (1) in this manual.

Step 7- Plug the round 8-pin DIN connector on USA SPEC CAS-H2y cable to adaptor labeled RADIO.

Step 8- If the vehicle has Rear-Seat-Entertainment system, wire Accessory power with a relay. [Refer to Fig. (2)]

Step 9- Connect your audio source to the RCA jacks on adaptor if AUX option is selected by DIP switch #1 = ON.

Step10- Plug CB-PA105 cable to adaptor where is labeled iPod.

Step 11- Reinstall radio back to dash only after a successful test is done.

Step12- Plug factory 14-pin cable to the 14-pin female connector on USA SPEC CAS-HXM cable. (Refer to Fig.3)

Step13- Plug the 14-pin male connector on USA SPEC CAS-HXM cable to the 14-pin female connector on USA

SPEC CAS-H2y.

Step14- Plug the orange color wire on CAS-HXM to PA 15-HON2 adaptor labeled XM.

Step 14- Go to Step 7, 8, 9, and 10.

1 2 ... 6 7 8 9 10 11 12 13 14

No comments

Usa-spec PA15-HON3 Owner's Manual Page 11