Usa-spec PA15-HON2 User Manual download pdf (Page 12)

CAS-H3y cable. Refer to Fig. (1).

Step 7-If the vehicle has Rear-Seat-Entertainment system, wire ACCessory power with a

Step 8-Connect your audio source to the RCA jacks on adaptor if AUX option is selected by

Step 9-Plug CB-PA105 cable to the adaptor where it is labeled iPod.

Step 10-Install radio back to the dash only after a successful test run is done.

Note: On some of HONDA radio, the 14-pin connector is located at bottom

side of radio chassis.

DIP switch #1 = ON.

relay. refer to Fig. (2)

where is labeled RADIO.

Step 6-Plug the 18-pin DIN connector on CAS-H3y cable to the adaptor

Step 5-Plug the factory 14-pin male connector to 14-pin female connector on

WARNING!!

Use only the iPod connection cable which comes with PA15-HON3 interface adaptor.

iPod connection cable from other sources may look similar, but they may damage your iPod.

CAS-H3Y

1 2 ... 7 8 9 10 11 12 13 14

No comments

Usa-spec PA15-HON2 User Manual Page 12